Motorola 6412 iii firmware updating

It's hard to watch. It has I haven't noticed, as I don't watch analog, but I'll take a look, using Jon Stewart as my litmus test. Rumor is there's a Scott Hanselman is a former professor, former Chief Architect in finance, now speaker, consultant, father, diabetic, and Microsoft employee.

He is a failed stand-up comic, a cornrower, and a book author. Disclaimer: The opinions expressed herein are my own personal opinions and do not represent my employer's view in any way.

Sponsored By. About Scott Scott Hanselman is a former professor, former Chief Architect in finance, now speaker, consultant, father, diabetic, and Microsoft employee. About Newsletter. Hosting By.

Share on Twitter or Facebook or use the Permalink. February 14, MPEG artifacts are very much dependent on many facts, but mainly how much re-compression your cable provider applies before leaving their head end. Some channels it is good e. Discovery HD , sometimes it is real bad e. Again, it may be your cable provider doing some funky stuff to the aspect ratio. Alex Hung. Bryan Bates. Do you get ABC? Not in Santa Cruz you don't.

I actually have a tivo and the Moto-comcast box. I heard rumors of Tivo blowing the comcast deal originally, but salvaging it so perhaps we'll see a comcast hd box with Tivo software soon. THAT would be sweet. I also have the stuttering, it's a firmware bug, so your new box will have the same problem Omar Shahine. I've been watching the Olympics too and I'm kind of disappointed by the quality.

I'm not getting any artifacts, but I find often times, it stutters is quick panning shots. The Olypmics in HD is cool, but so long as the camera stays still. Ken Robertson. That is actually pretty funny. I just used the same item as an example on my blog. I have been using my JP1 programmed successfully for a long time. When I use its own remote it works well.

Has anyone noticed this or have any clues? I have replaced batteries I am using device code Back to top. Posted: Tue Apr 24, am Post subject:. Generally, the Device setup code is meaningless unless you are using a built-in device code, which in this case I believe you are NOT since there IS no built-in Setup Code in the The device upgrade that you are using might shed some light on your problems, if it uses a protocol that perhaps is sub-optimal for your equipment. Please upload your Device Upgrade that you are using and provide a link to it here and someone will take a look.

Posted: Tue Apr 24, pm Post subject:. Capn Trips wrote:. BTW, with respect to upload the upgrade file here, I'm not sure how or where to do that to do that.

You should have better luck with it. Try it before you embark on a tedious analysis effort. Posted: Wed Apr 25, pm Post subject:.

The upgrade and the remote work, its just behaves as if sometimes the keypresses are not responded to. I can see from the red light the signal is going out. I suspected it was the Motorola box which does have some problems in this area.

However, when I use the Comcast remote, it works fine. I am also suspicious it could be the has lower output power. Any other clues? Behavior sounds typical of some sort of mismatch.